The best way I know to guarantee that you can have a warm shower every time is to regularly inspect and maintain your water heater. One proven way to maintain your hot water heater Visalia is to have a thorough check up on it at least every six months. If you are using modern water heater systems, the absolute worst way to maintain them is to try and perform the maintenance by yourself. These sophisticated water heater systems are best maintained by highly trained plumbers. Should you have a classic water heater system, here are four proven ways to perform its maintenance by yourself. Look Around Your shower and faucets are two areas you should check first before going anywhere near your water heater. Ensure that you check these two on a daily basis. One warning sign of a thermostat or heating problem is that your hot water becomes colder or hotter than it's used to be. Check the unit for any sign of leak - puddles and drips are two of the most common signs of a leak. Cracks and/or rust are two other sources of a leak. After determining the source of the leak, call on the plumbers to give you a proper assessment of what you should next. The plumber will tell you whether you have to repair the unit or replace it altogether. The one lesson I wish I had learned years ago about a gas water heater is that the burner flame has to be blue if the heating element is still functioning properly. If the heating element is not functioning properly, the burner flame turns to either yellow or orange. Should you discover that this is the case, it is time for the heating element to either be replaced or be adjusted. Again, my best advice is for you to call your local plumbing company to give you his professional advice on what next to do. Here are the top three DIY maintenance steps that you can perform; Examine The Pressure Relief Valve. The function of this valve is the release the pressure from the tank. If this valve is faulty, there is a pressure build up in the tank. If this pressure becomes too large, your tank can explode. You will need to make use of your water heater's manual to locate this valve. After you have located the valve, manually open it to ensure that it opens and closes effortlessly. Also, ensure you check the drain outlet - it has to be clean. If everything is normal, hot water should spray out this outlet. Drain The Tank. Here's a 7-step checklist for you to achieve this;
Shut off the inlet valve for the cold water as well as the circuit breaker of the water heater.
Connect a hose to this drain outlet and extend the hose till it reaches the outside of the house.
Drain the tank very quickly by opening the pressure relief valve. The major advantage of doing it this way is to remove any sediment from the tank. If this sediment is allowed to accumulate, it could harm the tank in the future.
After emptying the tank, close the pressure relief valve as well as that of the drain valve.
Examine the hot water faucet to determine if it is dry or not. If it is dry, turn on all the hot water faucet and open the cold water inlet valve so that the tank is filled to the brim.
Once the water starts flowing, turn off the water faucet.
Since the tank is now clean and without any sediment, switch on the circuit breaker to start heating the tank again.
Inspect The Anode Rod. The purpose of the anode rod is to attract all the corrosive constituents to itself to prevent the tank from rusting. The anode rod is metallic by nature and it stretches out into the tank. Since the anode is metallic and attracts rust elements to itself, it is only a matter of time before it starts to rust itself. Once it starts to rust, your tank would be the recipient of the rust components. To ensure that this is not the case and that your water heater lasts long, always conduct a regular check up on the anode rod. The real secret to having a durable water heater system is to have it checked on a regular basis. A secret weapon you can use to perform this regular checkup is to hire the services of plumbing experts especially Visalia’s Best Plumbing. Also, Visalia’s Best Plumbing is highly recommended if you are having any issue with your hot water heater system.